Power On The Camera - Bresser GameCamera Instrucciones De Uso

Optionally, the device may be powered through an
external power supply (optional accessory).
This manual only describes the power supply by using
batteries.
ATTENTION!
The manufacturer does not take any liability for any
damages caused by a wrong insertion of batteries or by
the use of a non-compatible power supply!
Open the bottom cover.
ATTENTION!
Make sure that the power switch is at the OFF position.
Open the cover of
compartement. Install the fully charged
batteries into the depot according the
polarities sign shown below. Always
insert two batteries with the same
polarity direction in each slot.
The following batteries with 1.5V output
can be used:
1. High-density and high-performance
alkaline batteries (Recommended)
26
the battery
2. Rechargeable alkaline batteries
3. Rechargeable NiMH batteries
There are two battery slots.
When in low-battery state, the camera will automatically
shut down after two indication sounds. Please change the
batteries in time. Remove used batteries from the device
immediately!
3.2 Insert the SD-card
Open the bottom cover. Insert SD-card into the card slot
with the unmarked side facing upwards. Please note that the
SD-card can only be plugged in in one direction. Make sure
that the write-protect switch of the SD-card is in the "write"
position; otherwise the camera cannot be switched on.

3.3 Power on the camera

Before switching on, please pay attention to the following:
1. Avoid temperature and motion disturbances in front of
the camera such as big leaf, curtain, air-conditioner,
air outlet of a chimney or other heat sources to prevent
false triggering.
2. The height from ground for placing the camera should
vary with the object size appropriately. In general, one
to two meters are preferred.