RL YSTAD Manual De Instrucciones página 7

a. Mount the pole (14) to the base by using locking lever (19) and washer (18).
b. Unscrew the height adjustment knob (15), and pull up the inner tube to adjust the height. Ensure that the knob is fully
tightened before proceeding.
c. Position the fan head motor (12), insert the tilt adjustment bolt (24) through the square hole of the coupling (13) and the
lower hole of inner tube as shown within the drawing detail view. Fully tighten the tilt range screw (21) which is already
located in the coupling (13). Then fit the tilt adjustment knob (23) onto the tilt control bolt (24) and tighten.
d. Insert the tilt range knob (20) through the top hole of the coupling (13), adjust the fan head to the desired position and
firmly tighten tilt range screw (21) and the tilt adjustment knob (23).
e.Position the back guard (7) onto the motor shaft (9), ensuring that the openings are aligned precisely with the lugs on the
motor housing and the handle is at the top, tighten with four screws (6).
f.Slide the fan blade (4) onto the notch on the motor shaft (9), locate fully and secure by tightening the fan blade securing
screw (5).
g.With the help of another person, position the front guard (2) against the back guard hold both guards together and close
the clip (3). At the end tighten the screw and the nut at the bottom of the guard.
Technical Information
Power Rating: 50 W
Service Value: 1,33 (m³/dak.)/W
Fan Sound Power Level: 58,3 // 62,4 // 66,1 dB(A)
Max. Fan Flow Rate: 66,83 m³/min
Stand By Power Consumption: 0 W
Max. Air Velocity: 3.3 // 3.8 // 4.0 m/s