Password - Promax DT-802 Manual De Instrucciones

4.6 Password

Access to the configuration of the equipment is protected by a password
(PASSWORD) to prevent improper access by unauthorized persons.
After starting up and scanning, press ENTER
order to get into the PASSWORD screen.
The default password is "2008".
To enter the password follow the steps below to EDIT a NUMERIC value. You
can apply these steps in order to edit any numeric value.
1.- Press ENTER
2.- Press RIGHT
units to thousands.
3.- If you want to change a number, press UP
4.- Once the value is edited, press ENTER
value.
After entering the password and if it is correct, you will access the setup menu.
If the password is not correct, you can make a new attempt.
Page 18
Figure 11.- Password.
to get into the PASSWORD option.
or LEFT
to decrease.
CONTROL MODULE. DT-802
key from the frontal equipad in
to move among the numbers, from
to increase or DOWN
to confirm the entered
04-2015