Fagor BMF-300X Manual Del Usuario página 11

Thoroughly dry all surfaces and removable
parts. Although this appliance automatically
defrosts, a layer of frost may occur on the
freezer compartment's interior walls if the
freezer door is opened frequently or kept
open too long. If the frost is too thick,
choose a time when there is less food in the
unit and proceed as follows:
1. Remove existing
accessories,
from the outlet and leave the doors
open. Ventilate the room thoroughly to
accelerate the thawing process.
2. When defrosting is completed, clean
your freezer
"Cleaning and Care" section (page 15).
Caution! Don't use sharp objects
to remove
compartment. Only after the interior is
completely dry should the appliance be
plugged back in and switched back on.
BMF-300X User's Manual.FINAL.indd 11 BMF-300X User's Manual.FINAL.indd 11
food and
unplug the appliance
as described in the
frost from the freezer
Door Seal Cleaning
Remember to keep door seals clean. Sticky
food and drinks can cause seals to stick
to the cabinet and tear when you open the
door. Wash seal with a mild detergent and
warm water. Rinse and dry it thoroughly
after cleaning.
Caution! Only after the door seals are
all
completely dry should the appliance be
powered on.
Replacing the LED Light
Warning: If the LED light is damaged,
contact the customer service help line for
assistance at 1-877-743-2467. To replace
the LED light:
1. Unplug your appliance.
2. Remove the light cover by pushing up
and out.
3. Hold the LED cover with one hand and
pull it toward you with the other hand
while pressing the connector latch.
4. Replace LED light and snap correctly in
place.
11
9/3/16 7:58 PM 9/3/16 7:58 PM