Toyotomi zibro RC-270 Instrucciones De Uso página 16

B
FILLING FUEL
Fill the removable tank in a suitable place since there can always be some spillage.
Follow the procedure below:
1 Make sure that the heater is switched off.
2 Open the upper lid º and lift the removable tank ¾ out of the heater (Fig. G).
Put down the removable tank (cap pointing upwards, handle on the floor)
and screw off the fuel cap using the fuel cap cover (Fig. H).
NOTE: Some drops may leak from the tank.
3 Take the manual fuel pump and insert the smooth, most rigid tube into the
jerrycan. Make sure that it is in a higher position than the removable tank
(Fig. I). Insert the ribbed hose into the opening of the removable tank.
4 Lock the valve on top of the pump (turn clockwise).
5 Squeeze the pump a few times, until fuel starts flowing into the removable
tank. As soon as this happens, there is no need to press any longer.
6 Check the fuel gauge of removable tank µ while filling the tank (Fig. J). Stop
filling by loosening the valve on top of the pump (turn anti-clock-wise), once
the gauge indicates that the tank is full. Never overfill the tank, especially not
when the fuel is very cold (fuel expands when it heats up).
7 Let the remaining fuel in the pump flow back into the jerrycan and carefully
remove the pump. Carefully screw the fuel cap back on the tank (Fig. K).
Clean off any spilled fuel.
8 Check whether the fuel cap is straight and tightened properly. Reinstall the
removable tank in the heater (cap down). Close the lid.
NOTE: Be sure to tighten the fuel tank cap and confirm that there is no
leakage of the fuel when the cap side is placed down. Then insert the
removable fuel tank into the heater.
C
IGNITING THE HEATER
A new heater may give off some smells for a short while, when it is used for the
first time. You should therefore provide extra ventilation or ignite the heater
outside the living room.
When you use the heater for the first time, first put the filled removable tank into
!
place, and then wait approximately 30 minutes before you ignite the heater. This
allows the glass fibre wick to soak up the fuel. Follow the same procedure when
you have completely burnt up all fuel from the tank, and after the glass fibre wick
has been replaced.
Before igniting the heater, always check the fuel indicator ² to see whether the
removable tank needs filling up (Green=full, Red=empty).
Always ignite the heater with the knurled wick adjustment knob
matches or a cigarette lighter.
Follow the procedure below:
4
6
empty
. Never use
G
H
I
J
full
K
L