Velleman CAMTVI2 Manual Del Usuario página 4

5. Installation
1. Remove the camera base. Loosen the hex screw on the outer ring.
Hold the outer ring and turn the base in an anti-clockwise direction to
unscrew it.
2. Choose your mounting spot. Take the base as a template and drill the
necessary mounting holes. If necessary, drill a hole for routing the
cables. Insert a nylon plug in each hole.
3. Pass the camera cable through the base and fix the bracket using the
included screws. If applicable, pass the cable through the routing hole.
4. Slightly adjust the camera lens and aim it toward the surveillance
area.
5. Replace the inner ring over the camera and hold in place.
V. 01 – 12/02/2015
CAMTVI2
4 ©Velleman nv