Maxon 295990-01G Instrucciones De Instalación página 11

NOTE: Ensure vinyl tape is attached to the 2 angle brackets before doing this procedure.
1. Position angle brackets (Kit item) fl ush
with RH and LH side of rear opening in the
pickup bed, where corner posts meet the
fl oor (FIG. 11-1).
2. Remove taillights (FIG. 11-1).
CAUTION
Before drilling holes in the pickup
bed, ensure there are no obstruc-
tions to drill bit or items that could
be damaged.
3. Use RH angle bracket as a template
to drill holes, for 3/8"-16 screws, in the
fl oor and corner post of pickup bed
(FIG. 11-1). Repeat for angle bracket
on LH side of pickup bed.
4. Bolt angle brackets and spacers to pickup
bed with 3/8"-16 screws, 3/8" fl at washers,
and 3/8"-16 nuts (FIG. 11-1). Repeat for
angle bracket on LH side of pickup bed.
LIFT CORPORATION Sht. 11 of 54 DSG#
INSTALLING ANGLE BRACKETS
M-15-10
3/8"-16 X 1" LG
BUTTON HEAD SCREW
ANGLE
BRACKET
3/8"
LOCK WASHER
(2 PLACES)
3/8"-16 NUT
(2 PLACES)
BOLTING ANGLE BRACKETS &
SPACERS TO PICKUP BED
Rev. D Date: 09/21/18
RH TAILLIGHT
ALUMINUM
SPACERS
(AS REQUIRED)
EDGES FLUSH
WITH REAR
OPENING
ALUMINUM
SPACERS
(AS REQUIRED)
FIG. 11-1