Before You Start; Assembly - Echo SRM-510ES Manual De Instrucciones

Before you start

Assembly

Read the operator's manual carefully to ensure that you assemble the product correctly.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
Loop handle version
1. Loop handle
2. Screw M5×35
3. Loop handle bracket
4. Nut
5. Screw M5×25
1. Bracket
2. Bolt M5×25
3. Convex of fitting plate
WARNING
6. Cushion
7. Concaves of cushion
8. Protrusions of loop han-
dle
9. Protrusions of bracket
4. Fitting plate
5. Notch of fitting plate
Before you start
Loop handle assembly
Assemble loop handle and bracket to drive shaft assembly.
Fit protrusions of loop handle and bracket into the respective con-
caves of cushion and make sure they are firmly dovetailed with
each other and fasten screws (M5×35).
Loosen bolts (M5×25) and adjust handle to a position that makes
operation comfortable.After adjustment fasten bolts (M5×25)
tightly to fix handle.
Install the handle so that it does not hide any of the
safety decals.
Installation of bracket
Fit bracket to mounting portion of angle transmission and fix the
bracket by holding fitting plate pressed from beneath and tighten
4 bolts (M5×25) lightly.
Get notches and convexes of fitting plate to face corresponding
convexes and concaves of bracket, and fix bracket tightening 4
bolts (M5×25) securely.
There are two types of shields: namely one used exclusively for
nylon line cutting head and another one used exclusively for met-
al blade. When metal blade is used, use the shield for metal
blade.
18
CAUTION