Kensington KeyFolio SecureBack Manual De Inicio Rápido página 6

Connect the Keyboard to Your iPad
1 Press the On/Off Switch for 1.5 to 5 seconds. The Power Indicator Light
NOTE: When you first turn on the Keyboard, both the Power Indicator Light and the
Bluetooth Status Indicator Light glow for 5 seconds. You cannot connect the Keyboard to
your iPad until only the Power Indicator Light glows.
2 On your iPad, tap Settings.
3 Open Bluetooth and make sure Bluetooth is on.
4 On the Keyboard, press the Bluetooth Connection Button. The Bluetooth Status
Indicator Light starts blinking for 10 minutes or until connected to a device.
5 The Keyboard now appears on your iPad screen. Tap Bluetooth Wireless Keyboard.
6 Your iPad screen displays a passkey. Enter the passkey on the Keyboard, and press Enter.
7 Your iPad screen shows the Keyboard as Connected. On the Keyboard, the Bluetooth
Status Indicator Light turns off.
8 You can now use your Keyboard to type in any app.
NOTE: To insure the K Lock key works correctly please ensure you do the following:
Home page > Settings > General > Passcode key. Verify "Require Passcode" is set to
"Immediately" otherwise a keyboard unlock will not require a passcode. Go back to
previous menu and verify "Passcode Lock" is On.
Note the following about the Bluetooth connection between the keyboard and your iPad:
• Keyboard will go into pairing mode if the On/Off Switch is pressed for 5 seconds or
longer then released (regardless of on or off state).
• Press the On/Off Switch for 1.5 to 5 seconds then release = toggle keyboard power
(on to off, off to on).
• First turn (Factory default, no prior paired BT devices) – enter pairing mode
automatically.
• In ON state only - Hold "CTRL + FN + F" for 3 seconds or more = reset to factory default
mode (clear all previously paired BT devices in memory), ALL LEDs should flash on and
off 3 times and keyboard should turn to off mode.
• If there is no active key press for 1 minute, the keyboard should go into sleep mode.
6
glows.