Fellowes POWERSHRED P-58Cs Guia De Inicio Rapido página 3

BASIC SHREDDING OPERATION
PAPER/CARD
1
Continuous operation:
Up to 5 minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Plug in and put
Continuous operation beyond
disconnect power
5-minutes will trigger
switch in ON ( – ) position
15-minute cool down period.
ADVANCED PRODUCT FEATURES
SAFESENSE TECHNOLOGY OPERATION
®
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
1
2
Touch test area and
Turn the shredder ON
look for the SafeSense
( I) to activate
indicator to illuminate
SafeSense
®
BASIC PRODUCT MAINTENANCE
OILING SHREDDER
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished
sheet capacity, intrusive noise when shredding and could
ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty
your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
A B
PAPER JAM
1 2
Press and hold Alternate slowly back and forth
Reverse (R)
2
Press Auto-On (I)
3
SafeSense is active
®
and working properly
®
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to Off (0)
A. Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum
operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will
not operate for the duration of the recovery time. See Basic Shredding Operation for more information
about the continuous operation and recovery time for this shredder.
B. SafeSense Indicator: If hands are too close to the paper entry, the SafeSense
®
and the shredder will stop shredding.
3 4
Set to Off (O)
and unplug
3
4
Check paper amount Feed paper straight into
paper entry and release
3
2
*Apply oil across entry Set to Reverse (R)
for 2-3 seconds
15
5 6
Gently pull uncut
Press and hold
paper from paper
Reverse (R)
entry. Plug in.
5
6
or
Feed into center of When finished
entry and release shredding set
to OFF (O)
indicator will illuminate
®
3