Samsung DW80R9950 Serie Manual De Instalación página 32

Installation
STEP 12 Completing the installation
1. Open the door and remove all foam, paper packaging, and unnecessary parts.
2. Turn on the circuit breaker you turned off before you began the installation.
3. Open the water supply valve to supply water to the dishwasher.
4. Turn on the dishwasher, and then select and run a cycle.
CAUTION
Make sure to check for water leakage on both ends of the water supply line and drain
hose connector.
5. Check if the dishwasher turns on properly and check also if there is any leak. If there is
no problem, turn the dishwasher off. Skip Steps 6 through 10 and go to Step 11.
6. If the leakage check code of "LC" appears on the window panel, press and hold the
Start button for more than 3 seconds to start draining. When the draining is complete,
unplug the dishwasher and close the water supply valve.
7. Check if the inlet valve leaks. If so, reconnect the 90º fitting with the hot water supply
line because they are not properly connected.
8. Once the leak is stopped, lay down the dishwasher as shown, and wipe out moisture
from the water leakage sensor.
9. Plug the dishwasher. Then, open the water supply valve and try a cycle.
10. If the "LC" information code continues to appear on the window panel, contact a local
service center.
11. Finally, attach the kick plate to the bottom of the dishwasher. While keeping the rubber
skirt of the door taut, push the kick plate from the front of the rubber skirt inward
underneath the door of the dishwasher. Make sure the gaskets of the kick plate are
flush with the floor and side walls. Then, tighten the screws to fix the plate.
32 English
DW9900R_DD68-00208A-00_EN.indd 32
Water leakage sensor
12/29/2018 1:57:21 PM