Vimar ELVOX PIXEL UP 40415 Manual De Usuario página 16

PIXEL UP: 40415
3. Entry control
The display gives feedback on the access control mode operation.
This mode is used to activate a previously configured command (e.g. lock, relay, etc.).
Press the button and the display to go into "Code Entry" mode.
Each time a digit key is pressed, the display will show the digit for a short time and then overwrite it with an asterisk.
The code entered is confirmed by pressing
The key is used to cancel any digits entered or if no digits have been entered, to return to the home page.
The device returns
the status information
associated with the
entry control phase:
After entering a code
two signals appear, de-
pending on the result of
the operation.
If the code corresponds
to the lock activation of
the local entrance pan-
el, the door open icon is
displayed instead of the
completed icon.
16
(Cancel) key
again.
Code
Confirm
Delete
Entering code
Access to the mode
for Entry control
Done Wrong Code
Done Not completed
(Key) key
Code
Code
Confirm Confirm
Delete Delete
Waiting for
confirmation
Door Opened
Door open
EN