• For safety,
DO NOT
... open the camcorder's
chassis.
... disassemble
or modify the unit.
... allow inflammables,
water or metallic objects to
enter the unit.
... remove the battery pack or disconnect
the
power supply while the power is on.
... leave the battery pack attached when the
camcorder
is not in use.
... place naked flame sources, such as lighted
candles, on the apparatus.
... expose the apparatus
to dripping or splashing.
... leave dust or metal objects adhered to the
power plug or an AC wall outlet.
... insert any objects in the camcorder.
• Avoid using the unit
... in places subject to excessive humidity or dust.
... in places subject to soot or steam such as near
a cooking stove.
... in places subject to excessive shock or vibration.
... near a television set.
... near appliances
generating
strong magnetic
or electric fields (speakers, broadcasting
antennas,
etc.).
... in places subject to extremely high (over 40°C
or 104°F) or extremely low (under O°C or 32°F)
temperatures.
... in places where air pressure
is low (more than
3000 m (9870 ft) above the sea level).
• DO NOT leave the unit
... in places of over 50°C (122°F).
... in places where humidity is extremely low
(below 35%) or extremely high (above 80%).
... in direct sunlight.
... in a closed car in summer.
... near a heater.
... in high places such as on a TV. Leaving the unit
in high places while a cable is connected
may
result in a malfunction
if the cable is caught and
the unit falls onto the floor.
• To protect
the unit, DO NOT
... allow it to become wet.
... drop the unit or strike it against hard objects.
... subject it to shock or excessive vibration during
transportation.
... keep the lens directed at extremely bright
objects for long periods.
... expose the lens to direct sunlight.
... swing it excessively
when using the hand strap.
... swing the soft camcorder case excessively
when the camcorder
is inside it.
... place the camcorder
in dusty or sandy areas,
such as on a beach.
•
To prevent
the unit from dropping,
• Fasten the grip belt securely.
• When using the camcorder
with a tripod,
attach the camcorder
to the tripod securely.
If the camcorder
drops, you may be injured and
the camcorder
may be damaged.
When a child uses the unit, there must be
parental guidance.
Declaration
of Conformity
Model Number : GZ-MG680U/650U/630U
Trade Name : JVC
Responsible
party : JVC AMERICAS
CORR
Address : 1700 Valley Road Wayne, N. J. 07470
Telephone Number : 973-317-5000
This device complies with Part 15 of FCC
Rules. Operation is subject to the following
two conditions:
(1)This device may not cause
harmful interference, and (2) this device must
accept any interference
received, including
interference that may cause undesired operation.
Changes or modifications
not approved by
JVC could void the user's authority to operate
the equipment.This
equipment has been
tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of
the FCC Rules.These
limits are designed to
provide reasonable
protection against harmful
interference
in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications.
However, there is no guarantee
that interference
will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference
by one or more
of the following measures: Reorient or relocate
the receiving antenna. Increase the separation
between the equipment and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced
radio/
TV technician for help.
This Class B digital apparatus
complies
with
Canadian
ICES-003.
Cet appareil numerique
de la classe Best
conforme a la norme NMB-003
du Canada.
EN
43