Samsung WA52M8650A Serie Manual Del Usuario página 38

Washing a load of laundry
NOTE
You can change the My Cycle settings by
repeating the process above.
The last saved settings will be displayed the
next time you choose the My Cycle function.
NOTE
If you press My Cycle and release it within
3 seconds, the previously saved cycle and
options appear. If you press My Cycle for 3
seconds or longer, the currently set cycle
and options are saved and the LED blinks
for 3 seconds.
Delay End
You can set the washer to start your wash
automatically at a later time by choosing a
delay time.
The hour displayed indicates the time at
which the wash will be ended.
1. Set your wash cycle.
2. Press Delay End repeatedly until the
delay time is set.
3. Press START/PAUSE. The "Delay End"
indicator will be lit, and the clock will
begin counting down until it reaches the
set time.
4. To cancel a Delay End function, press the
POWER button and then turn the washer
on again.
38 English
WA8600M_DC68-03774C-04_EN.indd 38
Pre Soak
Use this function when the laundry is
heavily contaminated or stained. This
function improves the wash performance by
adding a Pre Soak cycle.
• If you select this function, the total cycle
time is increased by 18 minutes.
• When the Pre Soak cycle starts, the
washer repeats a wash cycle after
supplying water and then performs a
18-minute soak cycle.
• When the Pre Soak cycle is complete,
the configured wash cycle starts without
draining water.
Eco Plus
This function sets the temperature
somewhat lower than the typical washing
cycle and extends the wash time slightly.
With laundry time slightly extended, it's
possible to keep the same level of washing
performance with cooler water. This function
reduces energy consumption and maintains
the quality of the wash.
Mist Shower
Mist Shower sprays water from a nozzle
that is independent of the main water
supply system. The water soaks the laundry
with additional water from the beginning
of the rinse cycle and provides a more
effective rinse. (The Mist Shower function
may not work if there is too large of a load
in the machine.)
2019-02-14 5:36:30