Electrical Equipment; Segurity Recomendations - Sima DAKAR MK45 Manual De Instrucciones

5. ELECTRICAL EQUIPMENT

The electrical equipment of the DAKAR
protection degree. The power supply on this machine has a low minimal tension coil to avoid any unexpected starting-
up of the machine. When there is a power cut or a fall of tension that causes the machine to stop, and once the
normal power conditions have been re-established, the motor does not start until the green button is pressed.
ATENCIÓN: The three-phase models leave the factory prepared to work at 400V.
ATENCIÓN: When necessary to use a three-phase power tension at 230V, we need to swap the positions of
the bridge plates in the motor terminals box, as indicated in the following figure:
ATENCIÓN: The extension cable
needs to have a minimum section

6. SEGURITY RECOMENDATIONS.

MK45 cutting tables manufactured by SIMA, S.A. has an IP54
8
ENGLISH
used to feed the machine
on the table as shown below