Installation Instructions; Key Dimensions And Specifi Cations; Location Requirements; Choose The Proper Location - KENMORE ELITE 796.8196 Manual De Uso Y Cuidado

KEY DIMENSIONS AND SPECIFICATIONS
Description
Electrical Requirements
Gas Requirements* NG:
Gas Requirements* LP:
Dimensions
Net Weight
Drying Capacity
*Gas Models Only

LOCATION REQUIREMENTS

IMPORTANT: Read all installation instructions
completely before installing and operating your dryer.
It is important that you review this entire manual before
installing and using your dryer. It contains detailed
instructions concerning electrical connections, gas
connections and exhaust requirements.

CHOOSE THE PROPER LOCATION

• Store and install the dryer where it will not be exposed
to temperatures below freezing or exposed to outdoor
weather conditions.
• Choose a location with a solid, level fl oor.
• If the dryer is being installed in a garage, place the
dryer at least 18 inches (45.7cm) above the fl oor.
• Properly ground the dryer to conform with all
governing codes and ordinances.
• To reduce the risk of electric shock, do not install the
dryer in damp or wet locations.
NOTE: Installing the dryer in a humid space, or installing or
storing the dryer where it will be exposed to the weather
or freezing temperatures, may result in rust or other
damage that is not covered by the product warranty.
IMPORTANT: If you are installing your dryer in a
manufactured or mobile home, please refer to the
Special Electrical Requirements for Mobile or
Manufactured Homes section.

CLEARANCES

• Most installations require a minimum of 5 ½ inches
(14 cm) of clearance behind the dryer for the exhaust
ducting.
• Allow minimum clearances of at least 1 inch (2.5 cm)
on the sides and back to minimize vibration and noise.
• Allowing additional clearance for installation and
servicing is recommended.
• Be sure to allow for wall, door, or fl oor moldings that
may increase the required clearances.
• Allow at least 24 13 / inches (63 cm) in front of the
16
dryer to open the door.
• Allow a minimum clearance of at least 5 ½ inches
(14 cm) for closet installation.

INSTALLATION INSTRUCTIONS

Dryer: 796.8196* Electric and 796.9196* Gas
Refer to the rating label
4–10.5 inches WC (Water Column)
8–13 inches WC
29 in. (W) X 31 15 ⁄16 in. (D) X 40 ¹³⁄16 in. (H), 56 ¾ in. (D with door open)
73.7 cm (W) X 81.1 cm (D) X 103.6 cm (H), 144.1 cm (D with door open)
Electric : 155.2 lb (70.4 kg) Gas : 159.6 lb (72.4 kg)
IEC 9.0 cu. ft.
Standard Installation – Side View
¹³⁄16
24
(63 cm)
Additional instructions for closet installations:
The closet door must allow for suffi cient airfl ow. Refer to the
diagram above for minimum vent opening requirements. A
louvered door is also acceptable.
8
in.
Standard Installation – Front View
5 ½ in.
15 ⁄16
31 in.
(14 cm)
(81.1 cm)
¾
56 in.
(144.1 cm)
1 in.
(2.5 cm)
in.
3"
(7.6 cm)
Vent
48 sq. in.
(310 sq. cm. )
Vent
24 sq. in.
(155 sq. cm. )
in.
3"
(7.6 cm)
1 in.
(2.5 cm)
29 in.
(73.7 cm)