Air Supply - Arrow PT15G Manual De Instrucciones

Description
Arrow's 15GPT angle finish nailer drives 15G finish nails from 1 ¼" (32mm) to 2 1/2"
(64mm) length. Its large cast aluminum body provides the power to easily drive nails
in to harder woods. The angled magazine makes it easy to reach tight corners and the
360-degree exhaust port minimizes dust and debris. It also features a quick release nose
cover to easily clear jams. Arrow's 15GPT Angle finish nailer is ideal for door and window
trims, exterior trims, and cabinet work, finish paneling, decorative trims and etc.

Air supply

1. Use clean, Dry and Regulated compressed air at 60-100psi (4-7 bar)
2. Never exceed maximum and minimum pressure. Too low or too high pressure would
cause noise wear and tear or misfiring.
3. When connecting air supply always keep hands and body away from discharge area of
tool.
4. A filter-regulator-lubrication is required and should be located as close to tool as
possible.
5. Keep air filter clean. A dirty filter will reduce the air pressure to the tool causing a
reduction in power and efficiency.
6. For better performance, install a quick connector in your tool and quick coupler on the
hose if possible.
7. Be sure all connections in air supply system are sealed to prevent air loss.
Fig 4.
Tool
OPERATING INSTRUCTIONS
5