Air Supply - Arrow PT23G Manual De Instrucciones

Description
Arrow's 23GPT pin nailer drives 23G headless pin nails from ½" to 1" (12mm to 25mm)
in length. It has a Die-cast aluminum body for strong driving and light weight hardened
oxidized magazine. Also included is a quick release latch for fast jam releasing and
fast loading. Headless pin nails are perfect for decorating without leaving a mark.
With economical air consumption and low noise, it's an excellent for furniture backs,
upholstery, paneling, drawer, rails etc.

Air supply

1. Use clean, Dry and Regulated compressed air at 60-100psi (4-7 bar)
2. Never exceed maximum and minimum pressure. Too low or too high pressure would
cause noise wear and tear or misfiring.
3. When connecting air supply always keep hands and body away from discharge area of
tool.
4. A filter-regulator-lubrication is required and should be located as close to tool as
possible.
5. Keep air filter clean. A dirty filter will reduce the air pressure to the tool causing a
reduction in power and efficiency.
6. For better performance, install a quick connector in your tool and quick coupler on the
hose if possible.
7. Be sure all connections in air supply system are sealed to prevent air loss.
Fig 4.
Tool
OPERATING INSTRUCTIONS
5