AEG BSS 4804 Instrucciones De Servicio página 33

1. Press the MODE button (2/1) repeatedly until the indica-
tor light (5) illuminate pink.
2. Connect a USB storage device directly into the port.
Playback then begins.
For operation, please refer to the section "Description of the
controls".
NOTE:
• Always directly connect a USB storage medium to the
USB port to prevent any malfunctions.
• The USB port is not designed for charging external
devices.
• The 5 V USB voltage is also activated in standby.
CAUTION:
Before removing the USB storage device, switch the device
to another mode using the MODE button (2/1).
Description of the controls
(1/2)
You can pause and continue music playback. Press again to
continue playback.
NOTE:
The activated function cannot be displayed for technical
reasons.
(5/4)
Press 1 x = Will re-start the current song from the begin-
ning. (Only in Bluetooth mode)
Press 2 x = Skip to the previous song.
Press 3 x = Skip to the song before the previous song.
(5/4)
Press to skip to the next song and the following songs.
RPT (3) (only in USB mode)
Activates the Repeat function.
• Press the button to repeat only the current title. The
indicator light (5) flashes quickly.
RAN (8) (only in USB mode)
Activates random playback. All titles are played back in a
random sequence. To deactivate the function again, press
the RPT button 2x.
NOTE:
The activated function cannot be displayed for technical
reasons.
/ (7) (only in USB mode)
If folders exist, the next or previous folder is selected. The
playback is stopped. Press the OK button (4), to start the
playback in the selected folder.
OK (4) (only in USB mode)
Playback starts in the previously selected folder.
Cleaning
CAUTION:
Do not submerge the device in water.
• Before cleaning disconnect from mains power supply.
• Clean the device with a soft damp cloth without deter-
gents.
Troubleshooting
Fault Cause
Unit cannot be Unit crashes
operated. and "hangs".
No audio signal Speaker is not
via the Bluetooth paired to the
connection audio source.
Volume too
low
Speaker cannot Pairing does
be connected not work
Audio source
is switched off
Bluetooth is
switched off
at the audio
source.
Bluetooth
version is not
supported.
Music tracks are Random
played back via playback is
USB in the wrong activated.
sequence.
English
33
Solution
Disconnect from the
mains for around
5 seconds. Then switch
the unit on again.
Check whether a connec-
tion exists. If necessary,
pair the speaker again to
the audio source.
Increase the volume on
the speaker
Increase the volume on
the audio source.
Check whether the audio
source supports the
A2DP protocol.
Switch on the audio
source
Switch on the Bluetooth
function in the audio
source.
Use a different playback
unit.
Press the RPT button 2x
(3).