Presto DL 400 SE Instrucciones De Instalación página 9

ENGLISH
1) INSTALLATION INSTRUCTIONS
2) PRECAUTIONS FOR USE (The product guarantee depends on the respect for these rules)
INSTALLATION and START UP
For products delivered with filters, these must be installed in accordance with the instructions.
Before commissioning any of our valves, it is essential to carefully drain
the pipes that can damage the mechanisms or water passages (PRESTO® heads that can be dismantled from
front).
Recommended operating pressure according to NF EN 816: 1 to 5 bars.
CLEANING
The chrome-plated coating of PRESTO® valves must be cleaned only with soapy water.
Abrasive, acid, alkaline or ammonia-based household products are prohibited.
3) Feed
4) High
5) High without valve
6) Built-in
7) High légionelle
8) Built-in légionelle
9) PART NUMBER
10) PARTS DELIVERED
11) Right Shut-off valve + seal
12) Angle Shut-off Valve + seal
13) Pin
14) Screw VBA TC 4x40 + washers
15) FLOW RATE (l/min)
16) Regulator
17) INSTALLATION
18) Hydraulic Connection
19) Top inlet
20) Built-in inlet
21) Maintenance
Spare parts: (see catalogue)
-DL cartridge 20/35 sec
-Pouch 20 safety wires
-DL priming pump
-Breast plate + swivelling button installed
1. Turn off the water inlet or close the shut-off valve
22) Dismantling the cartridge
23) Reassembly in reverse order
24) Replacing the shower grille Part number: 90185 (grille only) Part number: 90184 (grille + screw + limiter 10
l/min)
−Unscrewing expansion screw
− Replacement
25) Priming pump replacement
26) LEGIONELLE version connection
PART NO.:
PRESTO SHOWER TAP
27424 DL400 SE WITH RIGHT-LEGIO SHUT-
OFF VALVE
PRESTO SHOWER TAP
27426 DL400 SE WITH ANGLE-LEGIO SHUT-
OFF VALVE
27) This document is not contractual; we reserve the right to modify the characteristics of our products without
notice.
28) In order to avoid errors, verify properly the scale on paper with the dimensions indicated
29) PATENTED and REGISTERED MODELS
DESCRIPTION