Pet Fountain Reassembly - Drinkwell AVALON-AU-17 Manual De Funcionamiento

4. Once the Intake Plate is removed, remove the
Impeller (3-bladed propeller) which is held in
place magnetically. To remove the Impeller, use
a fingernail underneath a blade and lift out of
Pump (Fig. 14).
5. Once the Pump is completely disassembled,
you can clean the parts with soap and warm
water. Use a cotton swab or the "motor" brush
from the Drinkwell
the Pump's motor cavity and remove any build
up (Fig. 15). For added disinfecting and hard
water removal, clean the Pump's motor with a
diluted vinegar solution (20% white vinegar and
80% water). Be sure to rinse thoroughly with
fresh water.
6. Once the parts are clean and well rinsed, you
can reassemble the Pump for use.
a) Replace the Impeller.
b) Replace the Intake Plate.
c) Replace the Faceplate.
Pet Fountain
Reassembly
1. Place the Pump inside the Foam Filter (Fig. 16)
then place inside the square indention in the
Bowl. Make sure the circular opening, Pump
outflow on top of the Pump, is positioned in the
bottom right corner (Fig. 17).
2. Press down on the Pump to engage the suction
cups. Once the Pump is securely in place, feed
the Inline Plug of the electrical power cord over
and through the raised post and out the notch
on the bottom side of the Bowl (Fig. 18).
12
Cleaning Kit to clean inside
®
www.petsafe.net
Fig. 14
Fig. 15
Fig. 16
Fig. 17
Fig. 18
Electrical
power
cord rests
on top
Pump
Outflow