Sony Walkman MZ-R900 Manual De Instrucciones página 54

3
Turn the control towards . or
towards N> until " ON" flashes
in the display, and then press x.
, lights up in the display.
4
Turn the control towards . or
towards N> to select the elapsed
time.
One rotation of the control changes
the elapsed time setting (TIME :) by 1
minute, within a range of 1 to 99
minutes. To change the time quickly,
turn and hold the control towards
. or towards N>.
5
Press x.
The time is set.
6
Turn the control towards . or
towards N> to select the alarm
sound.
The following sounds can be selected.
Display
MELODY : 1
MELODY : 2
MELODY : 3
7
Press x.
The alarm is set.
The time remaining until the alarm is
shown in the display while the
recorder is stopped or play-paused.
To show the remaining time during
play, do steps 1 to 3.
To cancel setting the alarm
Press DISPLAY for 2 seconds or more.
54
-GB
Alarm sound
Classical music 1
Classical music 2
Beeps
To cancel Melody Timer
Select " OFF" in step 3 and then press the
jog lever (L) on the recorder or x on the
remote control.
To stop the alarm
Press any button. Note that the button's
original function will not activate at this
time.
z
• If you end the procedure after step 3, the
previous alarm setting is automatically used.
• After sounding for one minute, the alarm will
automatically stop and the alarm setting will
be canceled. If the alarm sounds during stop
mode, then the power will automatically turn
off 10 seconds after the alarm stops. If the
alarm stops while an MD is playing, the
playback will continue uninterrupted.
Notes
• The settings will be lost when you start
recording.
• The timer will begin counting down (using the
factory setting) from the moment you select
" ON" in step 3. The recorder will begin
counting down again from the moment you
change the elapsed time in step 4.