Bialetti BLT03 Instructiones De Uso página 25

POSITIONING AND STARTING
Follow the following precautions when positioning the appliance:
• Put the appliance on a horizontal surface.
• Put the appliance so that it is protected against overheating.
• Plug the power cord into the power socket.
Warnings:
Electrocution hazard. Never start the appli-
ance with damaged power cord.
Attention!
Burn hazard. The kettle support heats up
during functioning. Do not touch the kettle
surface.
When using the appliance for the fi rst time, rinse the kettle (9), then
boil clean water three/four times continuously. Empty the kettle (9)
and make sure it is clean.
• Unroll the whole power cord before connecting the appliance to the
electric power source (Fig. E).
• Open the lid (1) by pressing the opening button (2) Fig. C.
• Fill kettle (9) as required.
• For a proper functioning, make sure water amount inside the kettle (9)
is never below the minimum level or above the maximum one, as shown
on the level graduated indicator (10), Fig. B.
Attention!
Burn hazard. In case the kettle (9) is over-
fi lled, hot water may come out.
• Close lid (1) by pressing it down until it locks.
Attention!
Burn hazard. A wrong lid closure (1) may
cause water or steam leakages as well as an
irregular functioning of the water tempera-
ture sensor.
4. Use
25
EN