Installation and maintenance manual
WARNING! It is forbidden to use the
device for purposes other than those
intended. Any other use is to be
considered improper and therefore not
allowed.
N.B.:
During
construction stage of the systems,
current local rules and provisions are
complied with
3.7
Fundamental safety rules
The device must be used by adults;
Do not open or disassemble the device when
this is connected to the power supply;
Do not touch the device with wet or humid
body parts when barefoot;
Do not pour or spray the device with water;
Do not stand, sit and/or rest anything on the
device.
3.8
Information on coolant used
This device contains fluorinated greenhouse gas included
in the Kyoto protocol. Do not discard such gas into the
environment.
Coolant type: HFC-R134a.
N.B.:
Maintenance
operations must be carried out only by
qualified personnel.
4
INSTALLATION AND CONNECTIONS
WARNING! Installation, commissioning
and maintenance of the device must be
performed by qualified and authorised
personnel. Do not attempt to install the
device yourself.
4.1
Preparation of the installation site
The installation of the device must be carried out in
a suitable place in order to allow the normal use
and adjustment operations, together with ordinary
and extraordinary maintenance to be performed.
Therefore it is important to allow for the necessary
working space by referring to the dimensions
shown in Fig. .
the
design
and
and
disposal
Fig. 1 – Minimum space
Moreover, the premises must:
Have adequate water and power supply lines;
Be available and ready for connection to the
condense drain;
Be available and ready with
discharge pipes in case of damage caused to
the boiler or actuation of the safety valve or
breakage of pipes/connections;
Have containment systems in case of serious
water leaks;
Be sufficiently lit (where appropriate);
Not measure less than 20 m
Be frost-proof and dry.
adequate
;
3
pag. 8 / 23