Changing/Installing Batteries; Pre-Operation Inspection; Set-Up And Operation - RIDGID MR-10 Manual De Instrucciones

The RIDGID MR-10 Magnetic Loca -
NOTI E
tor conforms to all applicable EMC standards.
However, the possibility of it causing interfer-
ence in other devices cannot be precluded.
Changing/Installing
Batteries
The MR-10 Magnetic Locator is supplied with-
out the batteries installed. When the low bat-
tery indicator appears on screen, the batteries
need to be replaced. Remove the batteries
prior to storage to avoid battery leakage.
1. With device OFF, unscrew the battery
compartment cover (Figure 4). If needed,
remove batteries.
Figure 4 – Changing the Batteries
2. Install six new AA alkaline batteries (LR6),
observing correct polarity as indicated
in the battery compartment.
Use the batteries that are of same
NOTI E
type. Do not mix battery types. Do not mix
new and used batteries. Mixing batteries can
cause overheating and battery damage
3. Securely reinstall the battery compart-
ment cover.
Pre-Operation
Inspection
WARNING
Before each use, inspect your MR-10
Magnetic Locator and correct any prob-
lems to reduce the risk of serious injury
MR-10 Magnetic Locator
from electric shock and other causes
and prevent equipment damage.
1. Make sure the unit is OFF.
2. Remove the batteries and inspect for
signs of dam age. Re place if necessary.
Do not use locator if the batteries are
damaged.
3. Clean the equipment. This aids inspection
and helps prevent the tool from slipping
from your grip.
4. Inspect the locator for any damaged or
missing parts. Make sure the warning
label is present and readable (Figure 5).
If any issues are found, do not use the
magnetic locator until the issues have
been repaired.
–
Figure 5 – Warning Label

Set-Up and Operation

Do not place the Magnetic Locator any-
where electrical contact may occur. This
increases the risk of electrical shock.
Locating equipment uses magnetic fields
that can be distorted and interfered with.
Utilities may be present in a given area.
Follow local guidelines and one call/call
before you dig service procedures. Ex -
pos ing a utility is the only way to verify
its existence, location and depth.
Avoid traffic. Pay close attention to mov-
ing vehicles when using on or near road-
ways. Wear visible clothing or reflector
vests.
Set up and operate the Magnetic Locator
according to these procedures to reduce
the risk of injury from electric shock and
other causes, and prevent tool damage.
WARNING
5