Changing The Admin Pin - iStorage Diskashur PRO 2 Guia De Inicio Rapido

Note: Once the diskAshur PRO
and in a solid state. It can be locked down immediately by pressing the 'LOCK' button once or by
(strongly recommended) clicking the 'Safely Remove Hardware/Eject' icon within your
operating system.

Changing the Admin PIN

PIN Requirement
• PINs must be a minimum length of 7 and maximum 15 digits.
• Cannot contain all sequenital numbers (2345678 or 9876543).
• Cannot contain all repeating numbers (1111111).
• The SHIFT key can be used for additional combinations (e.g. SHIFT+1 is a separate
value to just 1).
To change the Admin PIN to your own unique 7-15 digit PIN, follow the steps below.
1. In Standby State (solid
press and hold down both the 'UNLOCK
and number '1' buttons.
2. Enter your Admin PIN (default
'11223344') and press the 'UNLOCK'
button.
3. In Admin mode (solid BLUE
and hold down 'UNLOCK + 2' buttons.
4. Enter your NEW Admin PIN and press
'UNLOCK' button.
5. Re-enter your NEW Admin PIN and
press 'UNLOCK' button.
6. To exit Admin Mode press the 'LOCK'
button.
4
has been successfully unlocked, the
2
RED LED),
LED), press
GREEN
Solid RED LED will change to blinking
BLUE LEDs
GREEN and BLUE LEDs blink rapidly together for
a few seconds then to a solid
solid BLUE LED indictaing the diskAshur PRO
'Admin Mode'.
Solid BLUE LED will change to blinking
solid BLUE LEDs.
Blinking GREEN and solid BLUE
a single GREEN LED blink and then back to blinking
GREEN and solid BLUE LEDs.
Blinking GREEN and solid BLUE
to a rapidly blinking BLUE LED and finally to a
solid BLUE LEDindicating the Admin PIN has been
successfully changed.
Solid RED LED indicates the drive is locked and in
the standby state.
LED will remain on
GREEN and
GREEN and finally a
is in
2
GREEN and
LEDs will switch to
LEDs change
4