Complete Installation - Whirlpool W10806906H Instrucciones De Instalación

Option D: No waste disposer –
with air gap
Screw-type clamps
Waste tee
Drain trap
1. Connect rubber end of drain hose
1
to air gap and cut if needed.
NOTE: Do not cut ribbed section.
Rubber
end
2. Attach drain hose to air gap with large
2
drain hose clamp (provided). Use pliers
to squeeze clamp open and move into
position. If the drain hose was cut, use
a 1 /
1
2
clamp (not provided).
3. Use a rubber hose (not provided) with
3
screw-type clamps (not provided) to
connect from waste tee to air gap.
24
Air gap
Large drain
hose clamp
Rubber hose
connector
Drain hose
" to 2" (38 to 50 mm) screw-type

COMPLETE INSTALLATION

Check that the power supply wire or cord does not touch
dishwasher motor or the lower part of the dishwasher tub.
60.
Power supply cord – Plug into a
grounded 3 prong outlet
Plug into a grounded 3 prong outlet.
61.
Reconnect power
Reconnect electrical power at the fuse box or circuit
breaker box.
NOTE: With the access panel off, start the dishwasher and
allow it to complete the shortest wash cycle. After the first
2 minutes, unlatch door, wait 5 seconds, then open door.
Check that there is water in the bottom of the dishwasher
tub. Check that dishwasher is working properly.