Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
This spray gun is rugged in construction, and is built to
yield exceptional value. The life of this product and the
efficiency of its operation depend upon a knowledge of
its construction, use and maintenance.
GRAVITY FEED HOOKUP
Air pressure for atomization is reg u lat ed at ex trac tor.
Amount of fluid is adjusted by fluid control screw on
gun, viscosity of paint, and air pressure.
FOR BEST PERFORMANCE, PLEASE BE SURE TO DO THE FOL LOW ING
• Tighten the gun to the cup securely with the nut and fitting supplied.
• Be sure to have the proper air pres s ure at the gun to operate. Proper air pres s ure for this tool should not exceed 50 PSI
• Adjust fluid control screw and spray width adjustment screw to your desired pattern before using on pro d uc t ion.
• Clean all parts after use.
Turn right to decrease flow, left to increase
In normal use, the nozzle wings are hor i zon tal as shown here. This pro vides a ver ti cal fan-shaped pat tern which
gives max i mum, even ma te ri al coverage as the gun is moved back and forth par al lel to the sur face being fin ished.
Set inlet pressure at no more than 50 PSI. For op ti mum per for mance,
some ma te ri als may spray better at PSI ratings below 50 PSI. If unsure,
always test at PSI ratings before using on final production. Try spray.
If it is too fine, de crease the air pres sure or open fluid control screw. If
the spray is too thick, close the fluid control screw. Reg u late the pat tern
width and repeat ad just ment of spray as needed.
9002B Rev. A : Parts Breakdown & Operating Manual
INSTALLATION
BEFORE USING THIS SPRAY GUN
ADJUSTMENTS
Air flow adjustment screw
Fluid Control Screw
Spray Width
Adjustment Screw
Air Flow
Adjustment
Screw
fluid control screw
Turn right to decrease flow, left to increase.
spray width adjustment screw
Turn right for round, left for fan.
SPRAYING
4
Gravity Feed
Cup
Atomization
Pressure
Gauge
Air Inlet
Air Hose
Spray pattern may be in fi nite ly adjusted
from round to flat.
Oil and
Water
Extractor
03/07/13
Publicidad
Tabla de contenido
