Operation; How To Operate Your Compressor - Drive MQ5800 Guía De Instrucciones

operation

4

How to Operate Your Compressor

NOTE
WARNING
Daily Use Operation
CAUTION
1. Before each use inspect the Compressor and nebulizer cup assembly
for damage or wear, replace as needed.
2. Place the Compressor on a table or other flat stable surface. Be sure
you can easily reach the controls when seated. Do not use this device on
the floor.
3. With the power switch in the O (OFF) position, plug the power cord into an
appropriate electrical wall outlet.
4. Connect one end of the tubing to the compressor air-outlet connector.
5. Assemble the nebulizer cup and add indicated medication to the nebulizer's
cup before use.
6. Attach the other end of the tubing into the air-inlet connector found at the
bottom of the nebulizer cup.
7. Turn on the Compressor by pressing the power switch to the I (ON)
position and begin treatment.
8. If treatment needs to be interrupted, simply press power switch to
O (OFF) position.
9. When the treatment is complete, turn off the compressor by pressing the
power switch to O (OFF) position and unplug the unit from the electrical
outlet.
10. Always unplug this device immediately after use.
Equipment not suitable for use in the presence of a flammable anesthetic
mixture with air or with oxygen or nitrous oxide. This device has no AP or
APG protection not intended for use with oxygen or oxygen enriched
environments.
.............................................................................................................................
DRIVE COMPRESSOR/NEBULIZER MODEL MQ5800, MQ5900, MQ5900P
.............................................................................................................................
Before initial operation, the nebulizer cup assembly should be
cleaned following instructions described in the "Cleaning" section.
Before connecting the power cord, make sure the I/O (ON/OFF)
switch is in the O (OFF) position.
The plug is also served to disconnect the device.
The Compressor is designed for intermittent use only. Do not
operate it continuously for more than 20 minutes for a single use
without turning it off and following a cooling period for least 40
minutes.
9