For Battery Tools; Cleaning The Tool - Worx WG584 Manual De Instrucciones

BATTERY STATUS (See Fig. F)
•
Before starting or after use, press the button
beside the power indicator light on the machine
to check the battery capacity.
•
During operation, the battery capacity will be
indicated automatically by the battery power
indicator. The indicator constantly senses and
displays the battery condition as follows.
•
For the machine with 2 battery packs with
different power, the power indicator light
displays the battery condition with the lower one
of the two batteries.
Battery indica-
tor light status
Five green lights
( ) are
illuminated.
Two, three or
four green lights
are illuminated.
Only one green
light (
is illuminated.
12
No light is illumi-
nated.
Only one light
is flashing twice
per cycle.
Only one light
is flashing three
times per cycle.
Only one light
is flashing four
times per cycle.
Cordless Blower
Battery condition
The two batteries are in
a highly charged condi-
tion.
The two batteries have
a remaining charge. The
more lights are illumi-
nated, the more battery
capacity.
The battery level of at
) least one battery pack is
very low. Please check
and charge the battery
pack.
At least one battery is
not fully installed or bat-
tery may be defective.
At least one battery is
over discharged (please
refer to the battery
charge condition),
please recharge the two
batteries at once before
use again or storage.
At least one battery is
hot, wait for them cool
down before start again.
The machine is over
load. Remove tool from
blowing area and try
again.

FOR BATTERY TOOLS

The ambient temperature range for the use and
storage of tool and battery is 0
The recommended ambient temperature range for
the charging system during charging is 0

CLEANING THE TOOL

Clean the tool regularly.
Warning! Keep your product dry. Under
no circumstances spray with water.
- To clean the tool, use only mild soap and a
damp cloth.
- Do not use any type of detergent, cleaner
or solvent which may contain chemicals
that could seriously damage the plastic.
- Self lubricating bearings are used in
your product, therefore lubrication is not
required.
o o
C-45 C-.
o o
C-40 C.
EN