Klarstein 10028293 Manual De Uso página 6

4. Connect wires from supply
and bracket to the wiring
terminals as follow:
Brown wire: "L"
Blue wire: "N"
Green/Yellow wire:
7. Assemble blade clips onto
the blades by tightening
the screws, flat washer,
spring washers and nuts
together.
10. Insert light kit cover onto
the light kit and secure
with three set screws.
5. Attach canopy to
bracket by aligning can-
opy side holes with the
bracket side holes. Lift fan
until the screws reach the
bottom of the slots and
then rotate the canopy
counterclockwise until the
screws drop into the
slot recesses.
8. Install the fan blade sets
onto the motor by tighten-
ing the screws and spring
washers
11. Install the shade onto the
switch housing.
the 6. Insert the other two set
screws and washers. Tight-
en all the screws, make
sure that the canopy is
secure and that you have
not trapped any wires. En-
sure that the slot of the
nylon ball hanger fits into
the guide pin of the upper
canopy.
9. Insert the male connector
into the female connector
securely as shown.
12. Install a light blulb (E27
MAX.60W, not supplied) to
the lampholder.Switch the
power on to check the op-
eration of the light kit and
fan.
6