Whirlpool WHSS 90F TS K Instrucciones De Uso página 14

! Use a duct with as few elbows as possible (maximum elbow angle: 90°).
! Avoid drastic changes in the duct cross-section.
! The company declines any responsibility whenever these regulations are not respected.
FILTERING OR DUCTING ?
! Your cooker hood is ready to be used in suction version.
To use the hood in filtering version the special ACCESSORY KIT must be installed.
Check on the first pages of this manual if the ACCESSORY KIT is furnished or must be bought separately.
Note: If furnished, in certain cases, the additional activated carbon filtering system may be installed on the hood.
Information about the conversion of the hood from suction version to filtering version is present in this manual.
Ducting version
In this case the fumes are conveyed outside of the building by means of a special pipe connected with the connection ring located on
top of the hood.
CAUTION!
The exhausting pipe is not supplied and must be purchased apart.
Diameter of the exhausting pipe must be equal to that of the connection ring.
CAUTION!
If the hood is supplied with active charcoal filter, then it must be removed.
Filter version
The aspirated air will be degreased and deodorised before being fed back into the room.
In order to use the hood in this version, you have to install a system of additional filtering based on activated charcoal.
CONTROLS
The hood is fitted with a control panel with aspiration speed selection control and a light switch to control cooking area lights.
T1. ON/OFF "Night Light"
T2. Main Light ON/OFF – Select the colour temperature
T3. Operation "ZEN Mode"
T4. Motor ON/OFF
T5. "POWER BOOST 1" function
T6. "POWER BOOST 2" function
T7. Automatic Mode"Cook Sense"
T8. Filter saturation indicator
T9. ON/OFF operating mode "Daily Air Sense"
T10. ON/OFF operating mode"Intensive Air Sense "
T1. ON/OFF "NIGHT LIGHT"
Press to switch the soft background lighting on or off.
T2. MAIN LIGHT ON/OFF – SELECT THE COLOUR TEMPERATURE
Press to switch the main light on or off.
• With the lights on, use your finger to swipe right or left over the SL1 LED strip to increase or decrease the intensity of the light.
To set the colour temperature of the lighting
• Press (and hold) again,
• use your finger to swipe right or left over the SL1 LED strip to set the intensity of the light colder or warmer.
If you do not change the colour for five seconds, SL1 will flash at the colour setting you have selected and an audible signal will
sound to indicate that the system has saved this configuration.
Please note: The light will come on at the last intensity you set before switching the appliance off.
T3. OPERATION "ZEN MODE"
14