Temper KEB-240-ST Manual De Instrucciones página 17

KEB 240-ST
Battery Crimping Tool
Power off
Press
automatically.
USB pot with Take the battery away from the tool, connect the USB with a
computer
computer to exchange the data. LCD showing symbol
Make sure that all the parts are clean without any oil, dust, especially on the
handle and control parts, to avoid the tool drop easily during the operation.
1) First press the for 3 s to turn on the power, the tool on the self inspecting for 1
s. the data will show last record, the tool is ready for working.
inspect the battery saturated or run out.
2) Select the right dies for the intended application,
Don't operate the tool without dies.
3) The connecting material shall be positioned in the center crimping head correctly, in
order to start the crimping procedure,
4) A crimping process is initiated by switching the trigger. It is defined by the closing
motion of the dies. The connection material is positioned in the stationary half of the
crimping dies and the moving part is approaching the compression point.
5) A crimping cycle is terminated when the dies contacted each other and when the
maximum crimping force is reached. After the crimping cycle is completed the piston
retracts automatically. Afterwards a new crimping cycle can be initiated or the
crimping process can be terminated by opening the latch and remove the connecting
material out of the head.
The crimping process can be interrupted at any moment by half releasing the trigger,
but the piston keep paused at moment.
for 3 s or leave the tool 30 mins to off the power
Battery Crimping Tool
Do not put your fingers into the head of the tool during operating. Your fingers could
be pinched very severely.
www.grupotemper.com