Elesa DD52R-E Instrucciones De Uso página 21

DD52R-E
The available options are:
- ALL (default): units of measure that can be selected: mm, inch, D
- nodEG : units of measure that can be selected: mm, inch
- OFF : the key is disabled and does not allow changing the selected measuring mode.
To program the parameters listed above, see paragraph 8.2.
7.3 Setting the absolute reference
After having selected the absolute measuring mode and stopped the shaft in the
starting position or in the reference position, press the key combination to set the
The value of compensation (offset) allows you to adjust the value shown on the
display in such a way that takes into account, for example, wear or tool change.
The system allows you to store up to 10 values of compensation. Press the key
combination
used (eg OFFS 0 ). Choose the desired compensation value by pressing the key
, and then press the key
The screen will display the absolute value to the sum of the values of the
parameters OriGin and OFFSET .
To program the offset values, see parameter OFFSET of paragraph 8.2.
0 _ _ 0 _ _
The available options are:
- L_OrG : the reference value and the compensation value are set as shown
above. Choose the desired offset among the 10 available values, then press
the key
- OFF : the keys combination
operating mode.
To program the parameters listed above, see paragraph 8.2.
aw. Always mention the source when reproducing our drawings.
absolute value to the sum of the values of the parameters OriGin
+
(absolute value of reference) and OFFSET (compensation value).
+
. The screen will display the last compensation value
It is possible to change the function of the keys combination
by setting the parameter 0 _ _ 0 _ _
to confirm;
Direct drive electronic position indicators
to confirm.
+ is not associated to any function in the
EN
21