Led Operation - Honeywell 69-2592EFS Guia De Instalacion

Installation Guide

LED Operation

The LED function is as follows:
• Flashing Green: when a button is pressed.
• Solid Green for 15 seconds: connected to the system.
• Solid Red: the remote did not connect to the system.
• Flashing Red: the battery needs to be replaced.
• Solid Amber: disconnected from the system.
• The LED will be off when the remote is idle.
Disconnect from RedLINK System
1 Press and hold the CONNECT button on the remote until the LED glows amber
(about 10 seconds) to disconnect from the RedLINK system.
If you replace a thermostat or Equipment Interface Module, disconnect the remote from the old device. Then follow the steps
on page 1 to re-connect the remote to the wireless network.
Operation
The remote has three buttons. The button that is pressed sets the thermostat to that
setting of the program schedule. That setting is held until another button is pressed
on the remote or the regular program schedule is resumed at
the thermostat.
Residential model:
• Home: Sets the thermostat to the Home setting of the
program schedule.
• Away: Sets the thermostat to the Away setting of the
program schedule.
• Vacation: Sets the thermostat to the Vacation setting of
the program schedule.
Commercial model:
• Occupied: Sets the thermostat to the Occupied setting
of the program schedule.
• Unoccupied: Sets the thermostat to the Unoccupied
setting of the program schedule.
• Holiday: Sets the thermostat to the Holiday setting of the program schedule.
69-2592EFS—01
2
M33097