General Guidelines - Velleman GAS/SET2 Manual Del Usuario

3.

General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.

Protect this device from shocks and abuse. Avoid brute force when operating the device.

Keep this device away from rain, moisture, splashing and dripping liquids.

Familiarise yourself with the functions of the device before actually using it.

All modifications of the device are forbidden for safety reasons. Damage caused by user modifications
to the device is not covered by the warranty.

Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.

Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.

Nor Velleman nor its dealers can be held responsible for any damage (extraordinary, incidental or
indirect) – of any nature (financial, physical...) arising from the possession, use or failure of this
product.

Keep this manual for future reference.
4. Features

cordless soldering iron

can also be used as a torch and as a hot blower

kit contains:
torch
o
3 soldering tips
o
deflector
o
sponge
o
solder wire
o
tip cap
o

portable soldering tool powered by butane gas

auto ignition
5. Overview
Refer to the illustrations on page 2 of this manual.
1 gas filler valve
2
ignition button
3
safety lock
4
head
a off
6. Fuelling/Refuelling the Soldering Iron
1. Before (re)fuelling, make sure to slide the flame switch [7] to the far left off position.
2. Follow the directions on the butane gas fuel can (not included). Insert the tip into the gas filler
valve [1]. Use a pumping action for best results. Use only high-quality butane gas.
3. After (re)fuelling, allow the gas to stabilize a few minutes before ignition.
7. Operation
7.1 Ignition
1. Make sure the exhaust vent is facing upward to avoid damaging your desk.
2. Press the safety lock [3] and simultaneously pull down the trigger with your thumb.
3. Hold the ignition button [2] and release the safety lock [3].
4. Slide the flame switch [7] to the right for a constant flame.
V. 01 – 24/11/2014
GAS/SET2
5 soldering tip
6
metal sleeve
7
flame switch
8
adjustment lever
b continuous
4 ©Velleman nv