Hardware Installation - IOGear Share Pro GWHD101KIT Guía De Configuración Rápide

Hardware Installation

STEP 1
Turn on both the video source and the display (TV or projector). Make
sure that the input source on your display corresponds to the HDMI
port that the transmitter is connected to.
STEP 2
Insert the transmitter into the HDMI port of your video source device.
STEP 3
Use one of the USB charging cables to connect to the micro USB port
of the transmitter to a type USB-A port on the source device to obtain
power. In a rare case that the source device has no USB port, please
use a 5V USB power adapter with a minimum of 500mA output (not
included in the package). At this time both the power LED (blue) and
the wireless LED (red) will light up solid and then the wireless LED
(red) will go out and come back on and both will remain solid.
In case the space around the HDMI port is too tight or the position is
too awkward and could cause a connection issue, use the HDMI cable
extender or the 90 degree HDMI adapter included in the package to
correct this issue or to increase the spacing.
STEP 4
Connect the receiver into a free HDMI port of your video display
device (TV, projector, etc.) using the provided HDMI cable and switch
your TV Input to the HDMI input source it is connected to.
2
Transmitter
3