Uso Por Carretera; Transport Preparation, Telescopic Drawbar And Feed Hopper F10 - ORKEL MP2000-X Manual Del Usuario

5.2 USO POR CARRETERA

La velocidad máxima de diseño de la ensiladora es de 40 km/h. Rebasar esta velocidad se considera peli-
groso. Además, la velocidad debe respetar los límites de velocidad nacionales. Antes de usar la máquina, el
operador debe asegurarse de que todas las cubiertas y compuertas estén cerradas y aseguradas.
Tenga cuidado con las líneas eléctricas aéreas. Altura máx. en posición de transporte: 4100 mm (F10)

5.2.1 Transport preparation, Telescopic drawbar and feed hopper F10

The levers referred to in this chapter can be found in
sección 4.2.4 "Lista de palancas". For illustrations, see
F10" in reversed order.
1. Lift the bale bridge and fold it over the wrapping table.
2. Raise the wrapping table (done from display unit,
position in order to ensure free passage when extending the drawbar.
3. Extend the drawbar (lever 6) until the transport safety lock engages (see
drawbar").
4. Fold back the wrapping table belt tensioner.
5. Disconnect the PTO drive shaft and secure it in transport position.
6. Disassemble the covers between the hopper and the elevator.
7. Fold in the hopper side covers, and secure them.
8. Fold the stairs into transport position, according to instructions given in
9. Raise the feed hopper (lever 3).
10. Secure the hopper in its upper position by closing the valves M2 and M3 on each side (see
11.2.1 "Valve chart for MP2000-X"
11. Retract all four hydraulic jack stands to their upper position (levers 1, 2, 4 and 5).
12. Disconnect hydraulic hoses.
13. Disengage the main power switch.
14. Rotate the wrapping arms to their transport position. See illustration in
sional sketch F10, transport
15. Move the tractor in front of the machine.
16. Connect the tractor to the draw bar.
17. Connect the el-cable and hoses for hydraulic/pneumatic brakes.
18. Check the road lights and brakes before driving.
19. Ensure that film roller storages, covers and hatches are all closed and secured.
User resources for the F10 feed hopper may be found at
5 TRANSPORTE
sección 4.2.3 "Esquema de palancas/controles"
capítulo 4.2.2 "Telescopic drawbar and feed hopper
sección 6.1.6 "Controles
).
mode".
www.orkel.com/qr
and
manuales") to its upper
sección 3.8.1 "Telescopic
sección 4.2.12 "Escaleras"
sección
sección 12.6.4 "Dimen-
51