Set-Up - Tribest SEDONA COMBO SD-P9150 Manual De Instrucciones

1. POWER Switch turns the Tribest Sedona Combo off and on.
2. °F/°C button will enable you to select the temperature display mode (Fahrenheit or Celsius).
NOTE: The default setting of Sedona Combo is in Celsius (°C). Once you set the machine to
Celsius or Fahrenheit, the Sedona Combo will remember your setting even after you turn OFF
the switch.
3. TEMP display is used for two separate functions:
• Setting Desired Temperature- During set-up this display will be used to set the desired
temperature of the drying chamber.
NOTE: The temperature of the drying chamber is regulated by a thermal sensor. The actual
temperature of the drying chamber may be affected by changes in the temperature and humidity
of the inflowing air, which may result in slight temperature fluctuations.
• Temperature Display- Displays your desired temperature setting.
-The 2 icons on the far left in the TEMP display indicate which of the two heating mechanisms
are active at any given time.
-When the top left icon is lit, the top heating mechanism is active.
-When the bottom left icon is lit, the lower heating mechanism is active.
-When the two icons light up alternately, both heating mechanisms are active.
-While the temperature displayed by the TEMP Display is set to the desired setting, the actual
temperature in the drying chamber may fluctuate up to ±5°C (9°F).
4. TIMER display will show the total number of hours set for each desired temperature. This timer
automatically counts down, showing the time remaining for dehydrating.
5. SET button has two functions:
• It enables you to set the temperature and the time.
-When initially setting the temperature, press the SET button once and the 3 digits of the
TEMP window will flash.
-When you press the SET button once more, the 2 digit TIMER window will flash.
1) Press the SET button once – While the TEMP window flashes, set the desired temperature
by using the 10 or 1 buttons to select your desired temperature.
2) When the TEMP window displays your desired temperature, press the SET button again to
finalize your temperature setting. Your desired temperature is now set up, and the TIMER
window will flash.
3) When the TIMER window flashes, set the desired hours by using the 10 or 1 buttons to
select the desired time, then press the SET button to finalize your choice.
NOTE:
• For faster and more accurate setting of the temperature and time, the Sedona Combo has 2
separate buttons of 10 and 1. The buttons under the 10 represent increments of ten, whereas
the buttons under the 1 represent increments of one.
• You may set the dehydrating time up to 99 hours.

SET-UP

EN
11