Charging The Battery; Switching On/Off; Registering (Pairing) And Connecting With The Cell Phone - Blaupunkt BT DRIVE FREE 414 Manual Del Usuario

Charging the battery

The BT Drive Free 414 is operated with a rechargeable battery. Charge the
battery completely before its fi rst use. Read the section "Battery information"
before starting the charging process.
You have to remove the BT Drive Free 414 from the steering wheel for the
charging procedure. The charging socket is located at the side of the hous-
ing that rests against the steering wheel. Connect the BT Drive Free 414 with
the vehicle charging adapter via the USB cable. Insert the vehicle charging
adapter into the cigarette lighter of the vehicle. The BT Drive Free 414 can
also be charged with the USB cable connected to the computer.
Note: As soon as the charger is connected, the BT Drive Free 414 switches off .
During the charging process, the MF button lights red. After the battery is
fully charged, the MF button lights blue. The charging process of the battery
lasts approx. 3 hours. Disconnect the BT Drive Free 414 from the charger after
it has been charged.
A completely charged battery supports a talk time of up to 7 hours and a
standby time of up to 300 hours. If the charge state of the battery becomes
low, the MF button fl ashes red every 3 seconds and you hear a warning beep
every 60 seconds.
20
02_BTDriveFree414_gb.indd 20-21 02_BTDriveFree414_gb.indd 20-21

Switching on/off

Switching on
To switch the unit on, press the MF button for approx. 3 seconds until you
hear a high-pitched signal tone and the MF button lights blue. Afterwards,
the MF button lights blue and the device is switched on.
Switching off
To switch the unit off , press the MF button for approx. 3 seconds until you
hear a low-pitched signal tone and the MF button lights red. Afterwards, the
device is switched off .

Registering (pairing) and connecting with the cell phone

Before you can use the BT Drive Free 414, you must register and connect it with
a Bluetooth-ready cell phone. Registering is a one-time process and required
only for the fi rst connection with the cell phone. The BT Drive Free 414 can
be registered with up to eight cell phones and be connected simultaneously
with two cell phones.
NFC smart pairing
The NFC smart pairing procedure is available for BT Drive Free 414 to make
the pairing much simply and quickly.
Please ensure that your mobile phone's OS version is Android 4.1, Windows 8,
Blackberry 7.0 or upper. The NFC sensor usually locates at the back of phone.
– Please enable the NFC function in the setting menu of your phone fi rst.
– Unlock your phone's screen to enable NFC detection, and touch the NFC
sensor area of BT Drive Free 414 to the back side of mobile phone. The
mobile phone will emit tone prompt if detect the speaker closing, and
the BT Drive Free 414 will turn on and enter pairing mode automatically.
NFC sensor
21
19.11.14 11:42 19.11.14 11:42