Publicidad
Idiomas disponibles
Idiomas disponibles
ELIMINATING THE ARM / DISARM CHIRPS:
The normal arming and disarming confirmation "chirps" can easily be turned on
and off using the valet toggle switch. To do this...
1. The valet switch must be in "off" position.
2. Turn the ignition key on, and then off.
3. Within 10 seconds of turning the ignition key off, move the valet toggle switch
to the on-off-on-off-on-then off position.
4a. If, before proceeding with step 1, the chirps were on, then you will hear 2 chirps
to indicate that the chirps have been turned off.
4b. If, before proceeding with step 1, the chirps were off, then you will hear 1 chirp
to indicate that the chirps have been turned on.
5. Whenever power to the system is disconnected (for repair or service of the
vehicle), the chirps will be active when power is re-connected. To turn the chirps
off, simply execute 1-3 above.
Note: Whenever the chrips are by-passed, the 3 chirp defect and 4 chirp intrusion
indicator will always operate. This feature will always warn you if there is a
defective sensor during the arming sequence or if the vehicle had been tampered
with in your absence, even if the normal arming and disarming chirps have been
turn off.
REMOTE PANIC OPERATION (CHANNEL 1):
The arming button on your key chain transmitter also functions as a "panic" switch
for instant activation of the alarm in emergency situations. To use the remote
panic switch;
1. Press and hold the button on the key chain transmitter for 3 seconds or more.
The alarm will immediately sound.
2. To stop the alarm, press and release the button on the key chain transmitter.
If the button is not pressed, the alarm will automatically stop after 30 seconds.
WARNING: Excessive pressure on the transmitter buttons will damage the
internal components on the circuit board. All that is required is a light push to the
button.
TRUNK RELEASE (CHANNEL 2) :
This security system has an additional feature that can be wired to a number of
different optional accessories. Some of the more common uses for this "channel"
are:
Remote Trunk Release - available for any vehicle with factory installed
electronic push-button trunk release.
Remote Car Starter - available for most automatic transmission, fuel
injected vehicles.
Remote Window Roll Up - available for most vehicles equipped with power
windows.
To activate the optional accessory:
1. Press and hold the 2nd button on the keychain transmitter for approximately
3 seconds.
NOTE: This feature will not operate when the vehicle's ignition key is turned "ON".
Page 4
Publicidad
