Connecting An Audio Device; Handsfree Calling; Receiving Calls; Making Calls - Sony MEX-BT3700U Manual De Instrucciones

Connecting an audio device

1
Be sure that both this unit and the
audio device are switched to
Bluetooth signal on.
2
Connect to this unit using the audio
device.
" " appears when the connection is made.
Connecting the last-connected audio
device from this unit
1 Be sure that both this unit and the audio device
are switched to Bluetooth signal on.
2 Press (SOURCE) repeatedly until "BT
AUDIO" appears.
3 Press (6).
" " flashes while the connection is being
made. And then "
connection is made.

Handsfree calling

Check that the unit and cellular phone are
connected beforehand.

Receiving calls

When receiving a call, a ring tone is output from
your car speakers.
1
Press (handsfree) when a call is
received with a ring tone.
The phone call starts.
To end a call
(handsfree) again, or (OFF).
Press
To reject an incoming call, press and hold
(handsfree) for 2 seconds.
Mic Gain adjustment
You can switch between two volume levels
("LOW" or "HI") to set a suitable level for the
other party during a call.
1 Press (5) during a call.
The item changes as follows:
MIC-LOW y MIC-HI
Note
The microphone of this unit is located on the rear of
the front panel (page 8). Do not cover the microphone
with tape, etc.
18
" stays lit when the

Making calls

In the case of making calls from this unit, redial
is used.
1
Press (SOURCE) repeatedly until "BT
PHONE" appears.
2
Press and hold
seconds or more.
The phone call starts.
To end a call
(handsfree) again, or (OFF).
Press
To call another phone, use your cellular phone,
and then transfer the call.
For call transfer details, check the following.

Call transfer

In order to activate/deactivate the appropriate
device (this unit/cellular phone), check the
following.
1
Press and hold
your cellular phone.
For details on cellular phone operation, refer to
your cellular phone manual.
Note
Depending on the cellular phone, handsfree
connection may be cut off when call transfer is
attempted.

Voice Dial Activation

You can activate voice dialing with a cellular
phone connected to this unit by saying the voice
tag stored on the cellular phone, then make a call.
1
Press (SOURCE) repeatedly until "BT
PHONE" appears.
2
Press (handsfree).
The cellular phone enters voice dialing mode.
3
Say the voice tag stored on the cellular
phone.
Your voice is recognized, and the call is
made.
(handsfree) for 3
(handsfree) or use