Beamz PLS Serie Manual De Instrucciones página 5

INTERNAL PROGRAMS
This mode allows either a single unit or several units linked together, to run one of eight shows that you choose.
The unit with various internal programs, from A1.x to A7.x.
IR CONTROL
The IR remote gives you control of various functions (See below). To control the fixture, you must
aim the remote at the front of the fixture and be no more than 30 feet away.
Note: Always set menu to d001. Mode when operate with IR.
POWER-Pressing this button willpower on blackout the fixture.
FULL ON-Press this button to fully light up the unit.
FADE/GOBO–No function
"DIMMER +" and "DIMMER -"-Use these buttons to adjust the output intensity
(25%~50%~75%~100%).
STROBE-This button will activate the strobe effect. You can control the flash rate by pressing the
"strobe" buttons by different times. Press this button ONE time to flash at highest rate. Press this
button a SECOND time to flash at medium rate. Press a THIRD time to flash at lowest rate. Press
a FOURTH time to exit this mode. If you press and hold this button the unit will begin to strobe.
COLOR-Press this button to enter Dimmer mode. Use the 1-9 buttons to select your desired
color. Adjust the output intensity using the "DIMMER +" and "DIMMER -" buttons.
Button 1 2
153.252 and Red Green
153.255
Function UV Green
153.258
1-9-When in either show mode or Colour mode, these buttons will allow you to select either a show or colour.
SOUND ON & OFF -These buttons activate and deactivate the sound active mode.
SHOW-This activates the show mode. Use the number buttons (1-4) to scroll through 4shows.
Press "show 0" to activate show mode and fixture run random show from show1-show4. Then press 1...4 to select show1-
show4.
FIXTURE CLEANING
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding
can cause greater accumulation of dirt on the unit's optics.
•
Make sure the area below the installation place is free from unwanted persons during servicing
•
Housings, fixations and installations spots( ceiling, truss, suspensions) should be totally free from any deformation
•
The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is
detected
•
In order to protect the fixture from overheat the cooling fans (if any) and ventilation openings should be cleaned
monthly.
•
The interior of the fixture should be cleaned annually using a vacuum cleaner or air-jet.
•
Clean with soft cloth using normal glass cleaning fluid.
•
Always dry the parts carefully.
•
Clean the external optics at least every month. Clean the internal optics at least every 30/60 days.
ATTENTION: We strongly recommend internal cleaning to be carried out by qualified worker!
3 4 5
Blue Red+Green Green+Blue
Blue UV+Green Green+Blue
6 7 8
Red+Blue White Red+Green+Blue
UV+Blue Red UV+Green+Blue
9
Full on
Full on
5