Install The Hardware - Axis D8004 Guia De Instalacion

Install the hardware

Pre-Installation
• Make sure to place the switch near a power source.
• Make sure to keep enough ventilation between the switch and the surrounding objects.
• This product is intended for indoor use only.
• When choosing a location, keep in mind the environmental restrictions. See
Specifications on page 10
• For locations of LEDs and connectors, see Hardware overview on page 9
Note
No software configuration is necessary.
Installation Steps
1. Attach the rubber feet to the bottom of the switch.
2. Fasten the brackets, if needed.
3. Connect a standard network cable to the port labeled NET on the switch.
4. Connect the other end of the cable to a network outlet alternatively via a PC or router.
5. Connect a network cable from the powered devices (network camera) to the switch,
port 1-4.
6. Connect the network cable from the switch to the powered device (network camera).
7. Connect the power cable to the switch.
8. Connect the power cable to a standard AC outlet.
Note
Use only the supplied power adapter to power the switch.
Power Notice
The switch is a power-required device, meaning it will not work until it is powered. Consider using
an UPS (Uninterrupted Power Supply) in order to avoid network data loss or network downtime.
AXIS D8004 Unmanaged PoE Switch
7