Tractor Controls - Snapper NXT 19542 Manual Del Usuario

Tractor Controls

Brake Pedal
Depressing the brake pedal applies the tractor
brake.
Cruise Control
This locks the ground speed control in forward.
The cruise control has five lock positions.
Electronic Dashboard
See Electronic Dashboard section.
Fuel Tank
To remove the cap, turn counterclockwise.
Ground Speed Pedals
The forward ground speed pedal controls the
tractor's forward ground speed. The reverse
ground speed pedal controls the tractor's reverse
ground speed.
Headlight Switch
This turns the tractor headlights on and off.
Height-of-Cut Switch
This adjusts the mower cutting height. Press the
switch UP to raise the mowing cutting height
and DOWN to lower the mower cutting height.
The height-of-cut is displayed on the electronic
dashboard.
Parking Brake
This locks the parking brake when the tractor is
stopped. See Parking Brake section.
Power Outlet (12V-DC)
12V
The power outlet is 12V-DC. Accessories must be
rated at 9 amps or less.
Power Take-Off (PTO) Switch
This engages and disengages attachments that
use the PTO. To engage the PTO, pull UP on the
switch. Push DOWN to disengage.
NOTE: The operator must be seated firmly in the
tractor seat for the PTO to function.
en
Reverse Mowing Option (RMO)
This allows the operator to mow (or use other
PTO driven attachments) while traveling in
reverse. To activate, turn the RMO key after the
PTO is engaged. The L.E.D. light will illuminate,
and the operator can then mow in reverse. Each
time the PTO is engaged, the RMO needs to be
reactivated if desired.
Starter Insert
When not in use, remove starter insert
and store out of the reach of children.
Remove the starter insert to shutdown
the engine.
Start/Stop Push Button
This starts/stops the engine and
STOP STOP
activates the electronic dashboard.
• Press and hold the push button to
start the engine.
• Press the push button when the
engine is running to shut down the
engine. The electronic dashboard
will turn off after 3 minutes.
• Tap the push button when the
engine is not running to activate the
electronic dashboard.
Throttle/Choke Control (Choke-O-Matic)
This controls the engine speed. Move the throttle/
choke control to the FAST position to increase
engine speed and SLOW position to decrease
engine speed. Always operate at full throttle. Move
the throttle/choke control to the CHOKE position
for starting a cold engine. A warm engine may
not require choking.
Transmission Release Lever
This releases the transmission so that the tractor
can be pushed by hand.
13