Description Of Symbols; Noise And Vibration - Silverline 793750 Manual Del Usuario

GB

Description of Symbols

The rating plate on your tool may show symbols. These represent important
information about the product or instructions on its use.
Wear hearing protection
Wear eye protection.
Wear breathing protection
Wear head protection
Wear hand protection
Read instruction manual
Caution!
DO NOT use with compressed gas cylinders!
Conforms to relevant legislation and safety standards
Environmental Protection
Air tools should not be disposed of with household waste. They
contain traces of oil and other lubricants. Please recycle where
facilities exist. Check with your local authority or retailer for
recycling advice.
V Volts
~
Alternating current
A Ampere
n No load speed
o
Hz
Hertz
W, kW Watt, kilowatt
(revolutions or reciprocation)
/min or min
-1
per minute
4
Original Instructions
Specifications
Maximum operating pressure: ................................6.3bar (90psi)
Air consumption: .................................................140L/min (5cfm)
Air Inlet: .................................................¼" BSP, supplied with two
(EN-6 'UK' and EQ-4 'European' types)
Minimum hose diameter: ...........................................9.5mm (
No load speed: .............................................................2,500min
Cutting capacities: ....................................................Steel: 1.2mm
Width of cut: ..............................................................5.5mm (
Weight: .................................................................................1.0kg
Noise and vibration information:
Level of sound pressure according to Machinery
directive 2006/42/EC:
Sound Pressure L : .......................................................... 90dB(A)
PA
Sound Power L : ........................................................... 101dB(A)
WA
Uncertainty K: ..........................................................................3dB
Vibration total values (triax vector sum) according to
Machinery directive 2006/42/EC:
Vibration emission value a : ...............................................4.6m/s
h
Uncertainty K: ....................................................................1.5m/s
The sound intensity level for the operator may exceed 85dB(A) and
sound protection measures are necessary.
As part of our ongoing product development, specifications
of Silverline products may alter without notice.

Noise and Vibration

Sound and vibration levels in the specification are determined according to
ISO 28927-3. The figures given can be used to compare similar tools tested
to this standard. These figures may be used to assess exposure to noise
and vibration levels.
The figures represent normal use for the tool in normal working condition.
A poorly maintained, incorrectly assembled or misused tool may produce
increased levels of noise and vibration. The total working period that
you can operate this tool must factor in periods where the tool is idle or
switched off. Allow frequent rest breaks when operating this tool.
It is in the interest of users to maximise their safety using the correct safety
equipment, like ear defenders that protect against loud or repetitive noise,
and anti-vibration gloves that minimise vibration. Do not operate the tool
with your hands below a normal comfortable temperature, as vibration will
have a greater effect.
Sound
The noise directive was introduced to protect against the risk to health and
safety arising or likely to arise from exposure to noise and risk of hearing.
The Directive can be used to define noise exposure and the physical
parameters, such as peak sound pressure and daily and weekly exposure
level. Particular attention should be taken to exposure level and duration.
For more information on the Noise Directives 2003/10/EC and 2000/14/EC,
please visit The European Agency for Safety and Health at work -
www.osha.europa.eu.
male airline quick connectors
⁄ ")
3
8
-1
.Aluminium: 1.4mm
⁄ ")
7
32
2
2