Fein WSG8-115 Manual De Uso página 28

OBJ_BUCH-0000000224-002.book Page 28 Tuesday, February 23, 2016 10:09 AM
en
28
Securing the workpiece (figure 14).
Secure the workpiece sufficiently. An
inadequately secured workpiece can, for
example, cause the grinding accessory to
jam. This can lead to kickback, cause the
workpiece to fall down, and lead to
other dangerous situations.
Dry grinding (figure 15).
Observe a lead angle of 20 – 40°. This will
ensure a good removal rate.
Apply uniform pressure with the power
tool and move it over the surface.
Avoid excessive heating of the work-
piece surface.
Cutting (figure 16).
Always work in an up-grinding motion,
so that the cutting disc will not jump out
of the cut.
Fig. 14
Fig. 15
Fig. 16