Control Panel; Timer Function - Danby DDR030BLWDB Manual Del Propietário

OPERATING INSTRUCTIONS

CONTROL PANEL

9
10
1 2 3
1. Smart Dehumidify: This function will automati-
cally adjust the humidity level with the fl uctuating
room temperatures. The humidity level cannot be
adjusted in this setting, it will stabilize between
45% - 55%.
2. Filter Button: The check fi lter light will illuminate
after 250 hours of operation. After cleaning the
fi lter, press the fi lter button to resume normal
operation.
3. Continuous Button: Press to activate the
continuous dehumidifying operation.
4. Fan button: Press to select normal or high fan
speed. The light will illuminate when set to high
fan speed.
5. Timer Button: Press to initiate the auto-start and
auto-stop feature. Set a start or stop time from
0.0 to 24 hours using the ( ) and ( ) keys.
6. ( / ) Buttons: The humidity level can be set
within a range of 35% to 85% relative humidity
in 5% increments. For drier air, press the ( )
button and set to a lower percentage value. For
more damp air, press the ( ) button and set a
higher percentage value.
7. Power Button: Press to turn the dehumidifi er on
or off.
8. Display: Shows the actual (± 5% accuracy)
room humidity level in a range of 30% RH to
90% RH. Otherwise, displays selection when
programming humidity or timer.
9. Bucket Full Light: The light will illuminate when
the bucket is full or incorrectly positioned inside
the cabinet. The compressor and fan operation
are terminated as a safety feature. When the
bucket is emptied or correctly re-positioned
the dehumidifi er will resume operation
automatically.
10. Auto Defrost Light: The light will illuminate
when frost builds up on the evaporator coils.
The compressor will cycle off and the fan will
continue to run until the frost melts.
8
4 5 6

TIMER FUNCTION

Auto Off Function
1. When the appliance is turned on, press the timer
button to activate the auto-stop timer. The auto-
stop light will illuminate.
7
2. Press the up and down buttons to change the set
time in 0.5 hour increments up to 10 hours and
then in 1 hour increments up to 24 hours.
3. Press the timer button to confi rm programming.
Auto On Function
4. When the appliance is turned off, press the
timer button to activate the auto-start timer. Set
the time as per the instructions above. Press the
timer button again to confi rm programming.
The auto on and auto off functions can be used at
the same time by fi rst setting one and then the other.
Both indicator lights will illuminate and the display
will count down to the appliance either turning off
or on, whichever function was set fi rst.
Note: The timer will not cycle the appliance on and
off indefi nitely. The auto on and auto off timers will
function one time and then the appliance will return
to regular functioning.
Turning the appliance on or off at any time or
changing the timer setting to 0.0 will cancel the
timer settings.
MEMORY AND AUTO RESTART SETTINGS
Each time the appliance is disconnected or
reconnected or in the event of a power failure, the
appliance will default to the last program setting
that was used.
If the appliance shuts off unexpectedly due to
a power failure, it will restart with the previous
settings automatically once power resumes.
4