GE GLE12HSLSS Manual Del Propietario E Instrucciones De Instalación página 12

REVERSING THE DOOR SWING (CONT.)
WARNING
leaving off parts, or overtightening screws, can lead
to the door falling off and result in injury and property
damage.
8. Remove the screw hole covers on the left side of
the middle mullion where the new hinge will be
installed. Place the screw hole covers over the
holes where you removed the old hinge.
9.
the unit into left side of the middle mullion. Place
the door to new installed left bottom hinge.
Bottom
Hinge
Screws
10. Remove the top hinge from the door. Set aside the
right top and bottom hinges. Retain for returning door
swing to original configuration.
11.
door. Move the door stop to the bottom left side of the
door. Line the door stop with locating pin, screw hole,
and hinge pin hole at the bottom left side of door. Secure
the stopper tightly using screw provided.
Bottom Left
12
Installation Instructions
Bottom Right
Locating
Collar
Screws
12.
hinge that came
with the unit into the
hinge hole on the
top left of the door.
13.
provided, attach the
top left hinge to the
top of the case.
14. Connect the wire and
redress wire around
the hinge cover, top
case and top of the door.
15. Place the new hinge cover on top of the hinge.
Hinge Cover
16. Turn the top door cap around and replace cap
with the opening over the hinge cover. Press into
place.
17. Pull down to remove the square insert on the left
side of the front case cover. Slide this insert into
the opening on the right side where the hinge
cover was.
18. Replace the front case cover using the screws
removed earlier. There are clips on the inside of
the case cover that fit into notches on the case.
Case
Cover
Clips
Notches in case
19.
Screws
49-60769 Rev. 5