Hunter 52271 Guía De Instalación Rápida página 2

bag
For installing the hanger bracket and wiring the fan
x5
For installing the blades
Single switch:
1. Connect the three grounding wires (green,
green/yellow stripe, or bare copper) coming
from the ceiling, downrod, and hanging
bracket.
2. Connect the white (grounded) wire from the
ceiling to the white wire from the fan.
3. Connect the black (ungrounded) wire from
the ceiling to the black wire and blue wire
from the fan.
Note: To connect the wires, hold the bare metal leads together and place a wire connector over them,
then twist clockwise until tight. Turn the splices upward and push them carefully back through the hanger
bracket into the outlet box. Spread the wires apart, with the grounded wires on one side of the outlet box
and the ungrounded wires on the other side of the outlet box.
Assembly Instructions
x2 x4
x15
bag
x15
bag
You will find these screws in
the motor's shipping blocks.
Connect the fan pull chain pendant to the
short chain coming from the switch housing.
Wiring Instructions
x2
Dual switches:
1. Connect the three grounding wires (green,
green/yellow stripe, or bare copper) coming
from the ceiling, downrod, and hanging
bracket.
2. Connect the white (grounded) wire from the
ceiling to the white wire from the fan.
3. Connect the black (ungrounded) wire from
the ceiling to the black wire from the fan.
4. Connect the second ungrounded (light) wire
from the celing to the blue wire from the fan.
bag
x2
For installing the canopy
Tighten the setscrew
with pliers. DO NOT
HAND TIGHTEN. If the
setscrew is not tightened
securely, the fan may fall.
x6
bag
Install a bulb into each
of the sockets. When
necessary, replace with
x2 bulbs of the same type
and wattage.
For installing the light kit
MP002 r121216 © 2016 Hunter Fan Company